Free UK delivery on every order

All number plate guides

Motorbike plates

How to fit a motorbike number plate to a tail tidy

To fit a motorbike number plate, first confirm that the bracket supports the plate and leaves enough clearance for the tyre, suspension and other equipment. Then follow the bracket and fixing manufacturers’ instructions. A tail tidy changes the mounting arrangement, so copying the old hole positions without checking can create problems. This guide helps you prepare the job and recognise when a motorcycle workshop should handle the fitment.

By A* Number Plates · Published · 4 min read

Check the mounting arrangement first

Our motorcycle rear plate measures 237 × 178mm. Before ordering, measure the existing plate and the tail tidy's support area. Check the bracket manufacturer's permitted plate dimensions and fixing method. A small central support may need an appropriate backing plate; do not assume the number plate itself should bridge an unsupported gap.

Also establish whether the tail tidy is intended for your bike model and year. A bracket supplied with another motorcycle may look similar while placing the plate differently. If its origin or installation is unclear, get the mounting checked before adding a new plate. The plate should complete a sound installation, rather than hide an unresolved bracket problem.

Make a template before drilling

Mark the outside dimensions on cardboard and offer it up to the bracket with the motorcycle securely supported. Locate the intended fixing points and check that the finished plate can sit squarely. Keep holes away from the registration characters and the plate's required markings. Do not drill through the lettering to reuse an awkward hole.

With a raised finish, plan enough room for the fixing head without it pressing on a character. If the old plate is cracked around its mounting holes, investigate the cause: overtightening, poor support or vibration could damage the replacement in the same place. Ask a workshop to assess a distorted bracket.

Use fixings suited to the bracket

Follow the instructions for the tail tidy, backing plate and fixing kit. Use the specified washers, spacers and locking method where required. Tighten as directed rather than using extra force to pull the plate against an uneven surface. The pads versus screws guide explains the general differences, but the motorcycle bracket's requirements come first.

Adhesive strips designed for a broad, flat car mounting area should not be assumed suitable for a narrow motorcycle bracket. Check the support area and fixing manufacturer's intended use. If you cannot establish that the attachment is suitable, use a motorcycle fitter instead of improvising a mounting method.

Keep the plate visible and check clearance

The DVSA motorcycle MOT manual requires the rear plate on modern motorcycles to be mounted towards the rear, vertically or as close to vertical as reasonably practicable. A plate that is missing, unreadable or insecure enough to fall off is a major defect. Tucking it almost flat under the tail is not a sensible fitting solution.

Check the number plate light, rear reflector and indicators against their own fitting requirements too. Wheel movement and suspension travel can change the gap to the plate; a check with the bike parked does not establish full operating clearance. Have that assessed professionally if you are unsure, particularly after a tail tidy or suspension change.

Inspect the installation before riding

Check that the registration is correct, the fixings are secure and no hardware changes the appearance of a letter or number. Make sure cables are routed safely and the light works. After fitting, follow any recheck instructions supplied with the bracket or hardware, and inspect the mounting during routine cleaning.

Choose the plate size before choosing the finish. Our motorbike sizing guide explains why an undersized blank is not a cure for an unsuitable bracket. Once the mounting is confirmed, compare Standard 2D and 4D 3mm motorcycle rear plates and order the format that fits your installation.

Official references

Official guidance checked on 25 October 2026. Product prices and options are those listed by A* Number Plates at publication; check your configured order total before payment.

Related guides

Choose a motorbike rear plate

Check the size, finish and registration before ordering. Free UK delivery on every order.